Velkommen til vår butikk på nett!

  • HJEM /
  • Crown I-Tech 5000 HD forsterker 2 x 2500W i 4 Ohm

Crown I-Tech 5000 HD forsterker 2 x 2500W i 4 Ohm

Crown

Bli den første som omtaler dette produktet

Tilgjengelighet: På lager i Norge

kr 45 725,00
Fra/måned
Måned Sum/måned
Konto kr 2 744,00
36 mnd kr 1 698,00
24 mnd kr 2 326,00
12 mnd kr 4 235,00
6 mnd kr 7 621,00
3 mnd kr 15 242,00
More info
More info
ELLER

Produktinformasjon

5 generasjon CLASS I forsterker. I-Tech 5000 yter hele 2x 2500W i 4 Ohm, og har BSS Omnidrive HD DSP prosessor med IIR og FIR Filter. Forsterkeren har ANALOG, AES/EBU, Cobranet, Ethernet og HiQnet tilkobling.

Crown I-Tech 5000 HD forsterker 2 x 2500W i 4 Ohm

Dobbelklikk på bildet for å se det i full størrelse

Zoom ut
Forstørre

Flere visninger

Detaljer

ul>li>- 2x 2500W i 4 Ohm, 2x 2000W i 2 Ohm, 2x 1250W i 8 Ohm , 4000W bridge/4Ohm, 5000W bridge/8Ohm/li>li>- Omnidrive HD prosessor med 24bit/192KHz A/D og D/A Convertere, og IIR og FIR filter/li>li>- Globalt powersupply 100/240 VAC, 50/60Hz/li>li>- USB kontakt i frontpanelet til preset og firmware oppgradering/li>li>- LCD panel for overvakning, forsterkerkontroll, preset valg og nettverks-oppsett/li>li>- Stor Kapasistans og utgansspenning ( 200V) gir enorme kraftresurser og rene transient topper/li>li>- HiQ net/li>/ul>

Tilleggsinformasjon

Teknisk info
  • Frequency Response (at 1 watt, 20 Hz - 20
  • kHz): ±0.25dB.
  • Signal to Noise Ratio below rated full-bandwidth
  • power, A-weighted: > 112 dB.
  • Total Harmonic Distortion (THD) at full rated
  • power: < 0.1%.
  • Intermodulation Distortion (IMD) 60 Hz and 7
  • kHz at 4:1, from full rated output to -35 dB:
  • < 0.2%.
  • Damping Factor (20 Hz to 100 Hz at 8 ohms):
  • > 5000.
  • Crosstalk (below rated power, 20 Hz to 1 kHz):
  • > 80 dB.
  • Common Mode Rejection (CMR) (20 Hz to 1
  • kHz): > 70 dB typical.
  • Latency (analog, digital inputs): 1.13 mS analog,
  • 1.81 mS digital (96 kHz).
  • A/D, D/A Converters: 24-bit 192 kHz Cirrus Logic.
  • Digital Input: AES/EBU, 24-bit, 32-96 kHz.
  • Onboard sample-rate converter.
  • Network: Onboard TCP/IQ and HiQnet,
  • compatible with standard 100 Mb Ethernet
  • hardware.
  • DSP: 24-bit conversion with 32-bit, floating-point
  • DSP processing. World-class IIR and linear phase
  • FIR filters. Has 64 assignable filters with 9
  • different filter types. Includes all-pass filters, over 2
  • seconds of delay available per channel, and dual
  • uncorrelated-noise and sine-wave generators.
  • Load Impedance: (Note: Safe with all types of
  • loads) Stereo: 1/2/4/8/16 ohms. Bridge Mono:
  • 2/4/8 ohms.
  • Input Sensitivity (referenced to 8 ohm rated
  • output): Adjustable in 0.1V steps from 1.4V to
  • 7.75V.
  • Required AC Mains: Universal AC input,
  • 100-240VAC, 50/60 Hz (±10%). Maximum AC
  • mains voltage 264VAC.
  • AC Line Connector: Five cordsets supplied with
  • amplifier (USA, UK, European, Australia, India).
  • Front Panel Indicators, Controls
  • and Connectors
  • Indicators: Bridge mode, Ready, Signal level,
  • Clip, Thermal error, Fault, Network data, Power,
  • AC mains.
  • LCD Control Screen and Controls: These let
  • the user adjust the amplifier's attenuation and
  • muting, configure the amp, set up and view error
  • monitoring (such as temperature and load
  • supervision), set IP and HiQnet addresses from
  • the front panel, and recall DSP presets. The
  • presets allow the user to quickly reconfigure the
  • amp for various applications.
  • Level Controls (Encoders): Speed-sensitive
  • rotary encoders, 0.5 dB steps, range 0 to -100
  • dB. These two knobs affect the Channel-1 and
  • Channel-2 output levels. They also select Menu
  • items and adjust parameter values that are
  • displayed on the LCD Control Screen.
  • Power Switch: Push-on/push-off switch with
  • built-in green AC mains present indicator.
  • USB 2.0 Connector: Accepts a USB drive to
  • transfer presets from the drive to the amplifier
  • DSP, and vice versa.
  • Back Panel Connectors, Controls,
  • and Indicators
  • Connectors: Balanced XLR analog inputs,
  • balanced analog XLR loop-thru outputs, AES/EBU
  • digital input, AES/EBU digital loop-thru output,
  • 4-Pole Speakon output connectors, binding post
  • output connectors, power cord, EtherCon®
  • Ethernet connector for networking via HiQnet or
  • CobraNet.
  • Reset Switch/Circuit Breaker: If the current
  • draw of the amplifier exceeds safe limits, this
  • breaker automatically disconnects the power
  • supply from the AC mains. The switch resets the
  • circuit breaker.
  • Preset Indicator: LED flashes to signal the
  • number of the current preset if active. LED is
  • green if the preset values have not been changed
  • once loaded. LED is yellow if the preset values
  • have been changed since they were loaded.
  • Construction
  • Cooling: Dual-zone, microprocessor controlled,
  • continuously variable speed fans, front-to-back
  • airflow.
  • Dimensions: 19 in. (48.3 cm) W x 3.5 in. (8.9
  • cm) H x 16.2 in. (41.1 cm) D.
  • Weight: 28 lbs (12.7 kg) net, 36 lbs (16.3 kg)
  • shipping.
  • Included Accessories: Rear rack ears, rack
  • screws, operation manual, power cords, foam
  • air filter.
Produktmerke Crown
Prisnivå kr 45 725,00
Bilde galleri NA

Produkttagger

Bruk mellomrom for å skille tagger. Omgi setninger med apostrof (').

Nylig viste produkter

  1. Crown I-Tech 12000 HD forsterker 2 x 4500W i 4 Ohm

  2. Carlsbro 12 - Scenemonitor

  3. Behringer HPX4000 Hodetelefoner

  4. Behringer F1520 Eurolive gulvmonitor

  5. Behringer DJX700 Pro DJ-mikser

Handlekurv

Du har ingen varer i handlekurven.

Avstemming

Hvilken gitarmerke liker du mest?

Mer informasjon
We Accept All Major Credit Cards

Nyheter, rabatter og spesialtilbud

Få tilsendt nyheter & tilbud via vårt nyhetsbrev

© 2012 SCENARIO AS. All Rights Reserved.
Fueled by: Benzin.no - Høyoktane løsninger